Securing Loco
Ensure Loco / Train inside fouling
mark.
Apply hand brakes tightly. Check
Efficiency.
Secure Locomotive with skids
tightly.
Check Repair Book for remarks
regarding not to shutdown, etc.
Ensure RF off and normal Battery
charging
Secure C/stand
Ensure TH in IDLE, RH in NEUTRAL and
remove Handle
ER and GF Slider Switches in OFF
CONT / FP Slider Switch in ON
Keep Isolation Switch in ISOLATE.
Record water & all oil levels in
Repair book and trip sheet
Press EFCO (Emergency Fuel Cutoff),
if not successful, try by MUSD / LLOB
After Shut down
Put OFF BLACK and WHITE labeled
Breaker
Ensure TLPR Working & wait till
TLPR Stops
Switch Off COMPUTER CONTROL &
TLPR Breakers
Open Battery Knife Switch
Note: If time not available, keep Computer
Control & TLPR Breakers ON.
Open Battery Knife Switch
Make remarks in Repair Book.
Post Lubrication
Post Lubrication will be done for a
period of 15 to 35 minutes
Timings is based on the working
condition of Engine – 1 hour prior to Shut Down
